三苄基氯化锡及其衍生物的合成

三苄基氯化锡最初用格氏法制得。Keiti等曾报道由锡和苄基氯直接制备,这时溶剂对反应的影响很大:用水作溶剂时得到三苄基锡;用甲苯作溶剂时得到二苄基二氯化锡;用正丁醇作溶剂时三苄基氯化锡的产率只有61％。在反应体系中加入KI、KBr或H_3PO_4等催化剂,三苄基氯化锡的产率也只有60％。本文用DMF作溶剂,AlCl_3-I_2作催化剂,并首次在反应体系中加入镁、锌、铝和钠等使副产物氯化亚锡还原成活性很高的金属锡,后者再与等基氯反应,可使三苄基氯化锡的产率提高到91.3％。文中还报导三种尚     

Aqueous p-nitrotoluene oxidation induced with direct glow discharge plasma

A plasma induced degradation process has been studied to treat 4-nitrotoluene (4-NT) present as an aqueous pollutant. The plasma was locally generated from a glow discharge around a tip of a platinum anode in an electrolytic solution. The influence of initial pH and Fe²⁺ on the degradation was examined. Major intermediates resulting from the degradation process were identified. Amongst the aromatic intermediates, p-hydroxybenzoic acid was the predominant degradation product. The formation of oxalic acid, malic acid was also observed. The final products of degradation were NH ₄ ⁺ , NO ₃ ⁻ and CO₂. Based on the analysis of intermediates and the kinetic considerations, the degradation was shown to follow a pseudo-first order reaction hence, a possible reaction pathway was proposed.     

Preparation of a set of selectively protected disaccharides for modular synthesis of heparan sulfate fragments: toward the synthesis of several <Emphasis Type="Italic">O</Emphasis>-sulfonated [β-D-GlcUA-(1→4)-β-D-GlcNAc]OPr types

A concise method for a stereocontrolled synthesis of a set of selectively protected disaccharides is reported. Coupling of the donor 11 onto acceptors 23 and 24, promoted by trimethylsilyl triflate-N-iodosuccinimide (TMSOTf-NIS), generated the disaccharides 25 and 26. Under typical conditions, condensation of the fully protected donor 12 onto acceptors 23 and 24 produced the disaccharides 27 and 28. The building blocks 25–28 were prepared in moderate yields having exclusive β-stereoselectivity. A unique pattern of protecting groups distinguished clearly between positions to be sulfated and functional groups remaining as free hydroxyl groups. Acetyl and/or levulinoyl esters temporarily protected the positions to be sulfated, while benzyl ethers were used for permanent protection. The anomeric positions were protected as allyl ethers, whereas the 4′-positions were masked as p-methoxybenzyl (PMB) ethers. The orthogonality of the PMB and allyl groups can then be used for further elongation of the chain by recurrent deprotection and activation steps. The hydroxyl group, OH-6, of glucosamine moieties was protected as a TBDPS ether to avoid oxidation. A five-step deprotection/sulfonation sequence was applied to the disaccharide 27 to generate the corresponding sulfated [β-D-GlcUA-2-OSO₃Na-(1→4)-β-D-Glc pNAc]-(1→O-Pro) 34.     

Optimization of the design and operation of FAIMS analyzers

Field asymmetric waveform ion mobility spectrometry (FAIMS) holds significant promise for post-ionization separations in conjunction with mass-spectrometric analyses. However, a limited understanding of fundamentals of FAIMS analyzers has made their design and operation largely an empirical exercise. Recently, we developed an a priori simulation of FAIMS that accounts for both ion diffusion (including anisotropic components) and Coulomb repulsion, and validated it by extensive comparisons with FAIMS/MS data. Here it is corroborated further by FAIMS-only measurements, and applied to explore how key instrumental parameters (analytical gap width and length, waveform frequency and profile, the identity and flow speed of buffer gas) affect FAIMS response. We find that the trade-off between resolution and sensitivity can be managed by varying gap width, RF frequency, and (in certain cases) buffer gas, with equivalent outcome. In particular, the resolving power can be approximately doubled compared to "typical" conditions. Throughput may be increased by either accelerating the gas flow (preferable) or shortening the device, but below certain minimum residence times performance deteriorates. Bisinusoidal and clipped-sinusoidal waveforms have comparable merit, but switching to rectangular waveforms would improve resolution and/or sensitivity. For any waveform profile, the ratio of two between voltages in high and low portions of the cycle produces the best performance.     

Characterization and electrochemical investigation of boron-doped mesocarbon microbead anode materials for lithium ion batteries

The structure and anodic performance of boron-doped and undoped mesocarbon microbeads (MCMBs) have been comparatively studied and the results obtained by XPS, XRD, SEM, Raman spectroscopy and electrochemical measurements are discussed. It is found that boron doping introduces a depressed d ₀₀₂ spacing and the larger amount of "unorganized carbon", which induces vacancy formation in the graphite planes and leads to a quite different morphology from that of the undoped material. Electrochemical charge/discharge cycle tests indicated that after boron doping the lithium intercalation was carried through at a somewhat higher potential, being attended by greater irreversible capacity loss. Electronic Publication     

Enhanced deep-red emission in donor-acceptor molecular architecture: The role of ancillary acceptor of cyanophenyl

Cyanophenyl as ancillary acceptor to modify donor-acceptor compound,plays an effective role in shifting the emission color to deep red and maintaining the luminescent efficiency.     

Pt-Sn脱氢催化剂浸渍状态的Sn-119和Pt-195的多核NMR研究

测定了Ｐｔ－Ｓｎ型催化剂浸渍状态下的Ｓｎ－１１９、Ｐｔ－１９５的多核核磁共振。当ＳｎＣｌ２／ＤＣｌ溶液体系中加入Ｈ２ＰｔＣｌ６以后，出现了Ｓｎ（Ⅳ）和另外一种Ｓｎ（Ⅱ）的构型，Ｓｎ－１１９峰向高场位移，说明部分Ｓｎ（Ⅱ）被氧化成Ｓｎ（Ⅳ），Ｈ２ＰｔＣｌ６的量对这种氧化性影响较小。而Ｈ２ＰｔＣｌ６／Ｄ２Ｏ溶液体系中加入ＳｎＣｌ２以后部分Ｐｔ（Ⅳ）被还原成Ｐｔ（Ⅱ），随着ＳｎＣｌ２量的增加，Ｐｔ（Ⅱ）     

以交联聚乙烯醇为载体的离子交换剂对蛋白质的分离性能

本文对阴离子交换剂ＤＥＡ—ＰＶＴ常压液相离子交换色谱分离蛋白质的性能、分离条件进行了探讨。结果表明其对蛋白质的分离性能良好，容易洗脱。与载体交联聚乙烯醇相比，ＤＥＡ—ＰＶＴ对蛋白质的非特异性吸附明显降低。     

Infrared-optical properties of vapour-deposited metal films

Spectroscopic infrared ellipsometry was applied to determine the optical constants of thin metal layers deposited on dielectric substrates such as glass or CaF(2). The layers were produced by evaporating gold or silver in a vacuum, and the coverage, that is the deposited mass per area, was chosen in the range 80-1200 mg m(-2) for gold, which refers to thicknesses in the lower nanometer range; in the case of the specifically lighter silver, about half the coverage was applied. At low coverage a metal island structure is obtained, which gives rise to surface-enhanced infrared absorption (SEIRA). Depending on the coverage, the deposited films exhibit either dielectric or metallic optical properties. Atomic force microscopy and conductivity measurements complement the spectroscopic observation.     

Continuous wavelet transform applied to removing the fluctuating background in near-infrared spectra

A novel method based on continuous wavelet transform (CWT) was proposed as a preprocessing tool for the near-infrared (NIR) spectra. Due to the property of the vanishing moments of the wavelet, the fluctuating background of the NIR spectra can be successfully removed through convolution of the spectra with an appropriate wavelet function. The vanishing moments of a wavelet and the scale parameter are two key factors that govern the result of the background elimination. The result of its application to both the simulated spectra and the NIR spectra of tobacco samples demonstrates that CWT is a competitive tool for removing fluctuating background in spectra.